Loading ...
Loading ...
Loading ...
DUCTING
1.Remove all tapes from the duct’s butterfly flaps and ensure they move up and down freely.
2.Position the butterfly flaps up.
3.Position the ducting over the top of the collection box and butterfly flaps. Note: If unsure about the ducting
please contact a rangehood installer.
4.If using a rangehood installer or roof plumber duct through ceiling and roof in accordance with the local,
state and national regulations and laws.
POWER
Using a plumb bob or spirit level determine the vertical line the flue surrounds will take.
The position of the 240V AC wall socket is that it must be accessible to turn on/off without removing any
covers.
Note: All electrical work must be carried out by a licensed electrician.
1.Uncoil power cord.
2.Plug into wall socket and turn on.
3.Test the fans and lights as per “Using Rangehood”.
4.If all okay turn off wall socket and unplug power lead.
FLUE SURROUND
Provided are 2 x flue surrounds both 500mm high. These are used to finish and cover the motor box and
installed ducting.
1.Lift and fit bottom flue surround, this fits into the groove in the Rangehood flat top.
2.Mark 1 hole on each side for the flue surround. Remove flue surround and drill holes.
3.Replace flue surround and secure each side at the top with suitable screws.
4.Mounting the second flue surround, this goes on the inside of the one previously installed.
5.Using a spirit level, plumb bob and tape measure position the flue bracket as high as possible. Once in
correct position mark holes and drill.
6.Secure the flue bracket with suitable screws.
7.Slide the second flue cover inside the first. Make sure the power cord is clear of the flue surround. Now
fasten to the flue bracket, make sure not to damage power cord.
8.Push 240V AC plug into power socket and turn on.
Note: Do not damage the power cord during the flue surround installation.
Loading ...
Loading ...
Loading ...