Loading ...
Loading ...
Loading ...
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds.
STARTING A PROGRAMME
Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. programme dial on a wrong
position).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator .
The drain pump can operate shortly
before the appliance fills water.
STARTING A PROGRAMME WITH THE
DELAY START
1. Touch the Delay Start button repeatedly until
the display shows the desired delay time. On the
display the indicator shows
2. Touch the Start/Pause button. The appliance
door locks and starts the countdown of the delay
start. The display shows the indicator .
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Delay Start button repeatedly
until the display shows the desired delay time.
On the display the indicator shows
Touch the Start/Pause button. The appliance
lock the door and starts the countdown of the delay
start. The display shows the indicator .
When the countdown is completed, the programme
starts automatically.
2. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
3. Touch the Delay Start button repeatedly
until the display shows and the indicator
goes off.
4. Touch the Start/Pause button again to start
the programme immediately.
Changing the delay start after the countdown
has started
To change the delay start:
1. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows the desired delay time.
3. Touch the Start/Pause button again to start
the new countdown.
THE AUTOADJUST SYSTEM LOAD
DETECTION
The programme duration in the display
is referred to a medium/high load.
After touching the Start/Pause button, the
maximum declared load indicator goes off, the
AutoAdjust System starts the laundry load
detection:
1. The appliance detects the load in the first 30
seconds. In the programmes where FlexiTime is
available, during this phase the FlexiTime bars
placed below the time digits play a
simple animation. The drum rotates shortly.
2. The programme duration could be adjusted
accordingly and could increase or decrease.
After further 30 seconds, the water filling
starts.
At the end of the load detection, in case of drum
overload, the indicator is flashing in the
display:
In this case, for 30 seconds, it is possible to pause
the appliance and remove the exceeding garments.
Once removed the exceeding garments, touch the
Start/Pause
button to start the programme
again. The AutoAdjust phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts anyway,
despite the overload. In this case, it will be not
possible to guarantee the best washing results.
About 20 minutes after the programme
start, the programme duration could
be adjusted again depending on the
capacity of water absorption of the
fabrics.
19
Loading ...
Loading ...
Loading ...