Loading ...
Loading ...
Loading ...
12
ON
GAS
COOKTOP BURNERS LEAK TESTING
lifting off stable blue flameyellow tip
z
Ensure all dials are set to OFF before connecting cooktop to gas supply.
z
After final gas connection is made, turn gas supply on and test all connections in gas supply
piping for gas leaks with a soapy water solution.
z
In order to avoid property damage or serious personal injury, never use a match or open
flame. If a leak is present, tighten joint or unscrew, apply more joint compound, tighten
again and retest connection for leak.
z
To check that the ignition system operates correctly, light each burner by itself, then all
burners in combination.
z
Check for a well-defined blue flame without any yellow tipping.
z
If any abnormality is evident, check that the components of the burner assembly are
located properly.
๎โ
No air shutter adjustment is possible on the cooktop. Correct operation is achieved with
factory installed settings for the correct gas type.
z
When installing the burner port ring, align the two locating pins in the bottom side of the
port ring with the locating notch and center holes on the top side of the simmer ring, and
make sure these are properly engaged.
z
Incorrect installation may produce a potentially dangerous flame and result in poor
burner performance.
z
If proper operation cannot be obtained, contact Customer Care or your nearest
Fisher๎&๎Paykel Authorized Service Center.
z
The rangetop must not be used until proper operation has been achieved.
Loading ...
Loading ...