Loading ...
Loading ...
Loading ...
Black plate (125,1)
北米Model "A1180BE-A" EDITED: 2013/ 6/ 11
NOTE
. Even during the illumination after
the driver’s door is opened, if the
ignition switch is turned to the “ON”
position, the com bination meter will
illuminate as usual.
. If the doors are locked by the remote
keyless entry system during the illumi-
nation after the driver’s door is opened,
the illumination will be turned off.
. Even while the illumination gradu-
ally turns off after the ignition switch is
turned to the “LOCK” position, if the
ignition switch is turned to the “ON”
position, the combination meter illumi-
nate as usual.
To change the setting:
1. Turn the ignition switch to the “LOCK”
or “Acc” position.
2. Press the trip knob to show “ ” or
“
” on the odometer and trip meter
display. The display can be switched as
shown in the following illustration by
pressing the trip knob.
*: “ ” or “ ”, and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter/gauge needles of your vehicle
has been set for activation “
” at the
time of shipment from the factory.
& Speedometer
The speedo meter shows the veh icle
speed.
& Odometer/Trip meter
1) Trip knob
This meter displays the odometer and two
trip meters when the ignition switch is in
the “LOCK”, “Acc” or “ON” position.
If you press the trip knob when the ignition
switch is in the “LOCK” position, the
odometer/trip meter will light up. It is
possible to switch the indications while
the odometer/trip meter is lit up. If you do
not press the trip knob within 10 seconds
of illumination of the odometer/trip meter,
the odometer/trip meter will turn off.
Instruments and controls/Meters and gauges
3-7
– CONTINUED –
3
Loading ...
Loading ...
Loading ...