Loading ...
Loading ...
Loading ...
Programmable functions
74
Display switch-off status
To save energy, the time display and
sensor buttons will go out after
10minutes, and only the Start/Stop
sensor button will flash. You can alter
this setting.
However, there is no switch-off in the
event of a fault.
Options
= Off
The time display and sensor
buttons will remain lit up while
the dryer is switched on.
= On (factory setting)
The time display and sensor
buttons will go out after
10minutes. . .
. . . if no further selection is
made after switching the dryer
on.
. . . after a program has
started.
However, the time display and
sensor buttons will remain lit
up for 10minutes after a delay
start time has elapsed, after
the end of a program, or at the
end of the Anti-crease phase.
“Switching on” the display again
- Turn the program selector to any
position (other than ) or touch a
sensor button. This will not alter a
running program.
- Open the door while the dryer is
switched on.
Appliance switch-off
The dryer switches off automatically
after 15minutes to save energy. This
time can be extended or reduced.
The dryer will switch off automatically
after 15, 20, or 30minutes
- if no further selection is made after
switching the dryer on,
- following the end of the Anti-crease
phase,
- after a program without an Anti-
crease phase has finished.
However, there is no switch-off in the
event of a fault.
Options
= After 15minutes (factory
setting)
= After 20minutes
= After 30minutes
Loading ...
Loading ...
Loading ...