Loading ...
Loading ...
Loading ...
ENGLISH-14 ENGLISH-15
Notes and cautions
In use
Note
X Safety device will cut off the power when the
vacuum cleaner was on for more than 30
minutes without any button input. In this case,
press the [ ] button on the body or unplug
the power plug and then plug it again.
X When you use the dusting brush or crevice
tool, you may feel vibration from the vacuum
cleaner.
X Please do not press the button of dust bin
handle when carrying the vacuum cleaner.
X The operating noise may change once the
safety device is activated to prevent the
dustbin from getting detached.
– The circular tube on bottom of the dustbin
prevents dust from spilling out.
Caution
X When removing the power plug from the
electrical outlet, grasp the plug, not the cord.
About storing
Note
X Hold the power cord and then press the [ ]
button since you can get injured if the power
cord may lose control while rewinding it.
X If the power cord is not rewinding well, press
the [
] button again after pulling the power
cord about 2~3 m
Caution
X Store the vacuum cleaner in the shade to
prevent deformation or discoloration.
Cleaning and maintenance
Note
X To make the dust filter cleaner, add neutral
detergent into lukewarm water and soak the
filter for 30 minutes before washing it.
X Do not wash the outlet filter with water.
X To maintain the best performance of the outlet
filter, replace them once a year.
X To prevent floors from scratches, inspect
condition of the brush and replace it if it is
worn down.
X Inspect the belt in the mini turbo to ensure
that it is in good condition. If the belt is broken
or cracked, replace it according to "To replace
the belt" instructions.
X Replacement filters are available at your local
Samsung distributors.
Caution
X Suction may reduce noticeably due to wrong
reassembling of the dust filter.
X Make sure the dust filter is completely dry
before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
X Dry the dust filter in the shade, not under
sunlight, to prevent transformation or
discoloration.
X You may wash the dust bin with cold water.
X When suction is noticeably reduced
continuously or vacuum cleaner abnormally
overheats, please clean the outlet filter.
X Please contact a nearest service center if you
cannot remove foreign matters from the hose.
X If tool is required for cleaning, please be
careful not to hurt the mesh.
Troubleshooting
PROBLEM SOLUTION
Motor does not start.
X Check cable, plug and socket.
X Leave to cool.
Suction force is
gradually decreasing.
X Check for blockage and remove.
Low or decreasing
suction.
X Please check filter and, if required, clean as illustrated in the instructions. if
filters are out of condition change them to new ones.
Cord does not rewind
fully.
X Pull the cord out 2-3 m and push down the [
] button.
Vacuum cleaner does
not pick up dirt.
X Check hose and replace if required.
Body overheating.
X Please check filters, if required clean as illustrated in the instruction.
Static electicity
discharge.
X Please decrease power suction.
X This can also occur when air in the room is very dry.
Please ventilate the room to air humidity become a normal.
SC07H40@@V SERIES_EN_00724P-07_170302.indd 14 2017-03-02 �� 6:55:03
Loading ...
Loading ...