Loading ...
Loading ...
subzero.com | 3
CAUTION
The outlet must be checked by a qualied electrician to
be sure that it is wired with the correct polarity. Verify
that the outlet is properly grounded (earthed).
WARNING
Do not use an extension cord, two-prong adapter or
remove the power cord ground prong.
SITE PREPARATION
Opening Dimensions
DESIGNER MODELS
654 mm
FOR OUTDOOR
MODEL
635 mm
OPENING
DEPTH
W
OPENING WIDTH
H
OPENING
HEIGHT
*89 mm finished returns will be visible and should be finished to match cabinetry
—
114 mm for outdoor model.
SIDE
VIEW
TOP VIEW
FRONT VIEW
89 mm
FINISHED
RETURN*
FRAMELESS CABINETRY
19
mm
TYPICAL
89 mm
FINISHED
RETURN*
FILLER
FRAMED CABINETRY
W W
OPENING DIMENSIONS
COLUMN AND TALL W H
457 mm Column 457 mm 2134 mm
610 mm Column 610 mm 2134 mm
762 mm Column and Tall 762 mm 2134 mm
914 mm Column and Tall 914 mm 2134 mm
DRAWER W H
610 mm Drawer 610 mm 876 mm
762 mm Drawer 762 mm 876 mm
914 mm Drawer 914 mm 876 mm
The depth of each designer model is 610 mm. Allow for
panel thickness when planning the nished opening depth.
A minimum 89 mm nished return is required on all sides of
the opening—114 mm for outdoor model. Framed cabinets
will require additional nished ller material behind the face
frame for a proper installation. Refer to the illustration.
DUAL INSTALLATION
When installing two units side by side in a dual installa-
tion, the opening width is the width of the two units added
together. A dual installation kit will be required for this instal-
lation. If a dual installation kit is not specied, a minimum
51 mm ller strip is required between units.
Dual installation kits are available through an authorized
Sub-Zero dealer.
Electrical
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
The electrical supply must be located within the shaded
area shown in the illustration and chart below. A separate
circuit, servicing only this appliance is required. Model
ICBID-24RO is designed and safe for use in outdoor
applications.
IMPORTANT NOTE: For indoor models, a ground fault circuit
interrupter (GFCI) is not recommended and may cause inter-
ruption of operation.
For the outdoor model, a ground fault circuit interrupter
(GFCI) is required to reduce the risk of electrical shock.
This appliance is equipped with an appliance inlet type
device. The appliance inlet is located at the bottom rear of
the appliance. When replacing the power cord verify the
replacement cord is rated HO5VV-F3G1.0 or equivalent to
ensure safe operation.
ELECTRICAL REQUIREMENTS
Power Supply 220-240 V AC, 50/60 Hz
Circuit Breaker 10 amp
Receptacle grounding-type (earthed)
ELECTRICAL SUPPLY LOCATION
WIDTH A
457 mm Models 152 mm
610 mm Models 241 mm
762 mm Models 318 mm
914 mm Models 394 mm
A
6 mm
108
mm
114 mm
FRONT VIEW
FLOOR
LEFT SIDE
OF OPENING
E
Electrical supply location
Electrical
Shock
Hazard
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions
Loading ...
Loading ...
Loading ...