Loading ...
Loading ...
Loading ...
Page 9 of 21
MODES AVAILABLE FOR SETUP
The heater has two different setup modes, Quick Connection and AP (Access Point). The
quick connection is a quick and simple way to set the unit up. The AP connection uses a
direct local wifi connection between your phone and the heater to upload the network
details.
When first turned on using the switch on the rear of the unit, the Ambient Light indicator will
flash rapidly, showing that the unit is in Quick connection mode, and ready to set up.
Please ensure your device is in the correct wifi connection mode for the connection type
you are attempting, the flashing of the Ambient Light indicator on your heater will indicate
this.
Connection Type
Frequency of Flashes
Quick Connection
Flashes twice per second
AP (Access Point)
Flashes once per second
CHANGING BETWEEN CONNECTION TYPES
To change the unit into AP mode, with the appliance in standby (Power switch on and unit
turned off), press and hold the Mode button for 5 Seconds.
To change back to Quick connection mode, turn the appliance off using the switch on the
rear. Leave turned off for 10 seconds before returning the switch to the on position. After a
few seconds the Ambient Light indicator will start to quickly flash to indicate the unit is in
Quick connection mode.
TURNING WIFI OFF
With the appliance in standby mode (Power switch on, but turned off), Press and hold the
On Off Button for 3 seconds. The unit will bleep and the Light button will go out.
TURNING WIFI ON
Turn the appliance off using the switch on the rear. Leave turned off for 10 seconds before
returning the switch to the on position. After a few seconds the Ambient Light indicator will
start to quickly flash to indicate the unit is in Quick connection mode.
Loading ...
Loading ...
Loading ...