Loading ...
Loading ...
Loading ...
30
HOW TO MAINTAIN THE EXERCISE BIKE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO TROUBLESHOOT THE CONSOLE
If the console does not turn on, make sure that the
power adapter is fully plugged in. If there are exterior
wires on the console, make sure that the connectors
on the wires are oriented correctly and are connected
firmly.
If you are having problems connecting the console
to a wireless network, or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) near the USB port on the
console. Using a bent paper clip, press and hold the
reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug and then plug in the
power adapter. Once the console turns on, check for
rmware updates (see step 6 on page 26). Note: It
may take a few minutes for the console to be ready for
use.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter. Next, locate the Reed Switch (57) on the
left side of the exercise bike. Slightly loosen the two
M4 x 20mm Screws (87).
Next, turn the Left Crank Arm (19) until a Magnet (62)
is aligned with the Reed Switch (57). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 20mm Screws (87).
Plug in the power adapter and turn the Left Crank Arm
(19) for a moment. Repeat the procedure above, if nec-
essary, until the console displays correct feedback.
When the Reed Switch (57) is correctly adjusted, plug
in the power adapter.
A
19
87
62
57
MAINTENANCE AND TROUBLESHOOTING
Loading ...
Loading ...
Loading ...