Loading ...
Loading ...
Loading ...
INSTALLATION
9
Mechanical Splice Kit with Plastic Insulators
(for 14, 12 and 10 Gauge AWG Wire, or 2, 3 and
5.5mm
2
Wire)
1. Cut o motor leads. Stagger the lead and wire length so
that the second lead is 4 inches (101.6mm) longer than
the rst lead and the third lead is 4 inches
(ioi.6mm) longer than the second.
2. Cut o wire ends. Match colors and lengths of the power
supply wires to colors and lengths of the motor leads.
3. Trim insulation back 1/2” (13mm) from the cable ends
and motor lead ends.
4. Unscrew plastic caps from insulators. Place a cap
and a neoprene gasket sleeve on each wire end to be
spliced. Slide the insulator body onto wire end.
5. Insert the wire end into the butt connector and crimp.
Match cable and motor wire colors.
6. Center the insulator body over splice and slide the
neoprene sleeves into the body as far as they will go.
Screw caps onto the insulator body and tighten by hand
for a strong, waterproof splice.
Insulator Body
Butt Connector or Crimp or Solder
End Cap
Gasket
Gasket Sleeve
in Place
Cap screwed onInsulator
Body
Centered
Over Splice
1/2” 1/2”
12.7mm 12.7mm
Loading ...
Loading ...
Loading ...