Loading ...
Loading ...
3
AU
Installation
! Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe installation
and operation of the appliance.
!
Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
! The appliance must be installed by a qualified
professional according to the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.
Positioning and levelling
! It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
! This cooker should be installed directly on! This cooker should be installed directly on
! This cooker should be installed directly on! This cooker should be installed directly on
! This cooker should be installed directly on
the floor. Do not install this cooker on anthe floor. Do not install this cooker on an
the floor. Do not install this cooker on anthe floor. Do not install this cooker on an
the floor. Do not install this cooker on an
artificial base of any kind.artificial base of any kind.
artificial base of any kind.artificial base of any kind.
artificial base of any kind.
! Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).
! Important: Do not install this appliance! Important: Do not install this appliance
! Important: Do not install this appliance! Important: Do not install this appliance
! Important: Do not install this appliance
adjacent to the door or other means ofadjacent to the door or other means of
adjacent to the door or other means ofadjacent to the door or other means of
adjacent to the door or other means of
access to minimise the likelihood of personsaccess to minimise the likelihood of persons
access to minimise the likelihood of personsaccess to minimise the likelihood of persons
access to minimise the likelihood of persons
using the door making contact with pans onusing the door making contact with pans on
using the door making contact with pans onusing the door making contact with pans on
using the door making contact with pans on
the hob surface.the hob surface.
the hob surface.the hob surface.
the hob surface.
To install the appliance correctly:
• Place it in the kitchen, dining room or the bed-sit
(not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 200 mm
away from them.
• If the cooker is
installed underneath a wall
cabinet, there must be a
minimum distance of
420 mm between this
cabinet and the top of
the hob.
This distance should be
increased to 700 mm if
the wall cabinets are
flammable (
see figure
).
• Do not position blinds behind the cooker or less
than 200 mm away from its sides.
• Any hoods must be installed according to the
instructions listed in the relevant operating manual.
Levelling
If it is necessary to level the
appliance, screw the
adjustable feet* into the places
provided on each corner of the
base of the cooker (
see figure
).
The legs* provided with the
appliance fit into the slots on
the underside of the base of
the cooker.
Electrical connection
Ovens with a three-pole power supply cable are
designed to operate with alternated current at the
supply frequency and voltage indicated on the data
plate (at the bottom of the oven dashboard). The
earthing conductor of the cable is the yellow-green
conductor.
HOOD
420
Min.
min.
650
mm. with hood
min. 700 mm. without hood
mm.
600
Min. mm.
420
Min. mm.
Opening the terminal board:
••
••
• Using a screwdriver, prise
on the side tabs of the
terminal board cover;
••
••
• Pull open the cover of the
terminal board.
To install the cable, proceed as follows:
••
••
• Remove the wire clamp
screw and the three contact
screws L-N-
• Fasten the wires beneath
the heads of the screws using
the following color scheme :
Blue (N) Brown (L) Yellow-
Green
• Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
NL
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
EARTHED.EARTHED.
EARTHED.EARTHED.
EARTHED.
! The cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the
cooker Rating Plate. All electrical wiring from the
consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type
and current rating as above.
! the supply cable must be positioned so that it
Loading ...
Loading ...
Loading ...