Loading ...
Loading ...
Loading ...
© 2017 DJI All Rights Reserved.
9
Connection
Tools Required: Power distribution board (PDB)*, electric soldering iron
and soldering tin
1. Solder the ESC’s black and gray power cables to the pads on the PDB.
2 Connect the signal cable to your ight controller. The signal cable’s gray
wire transmits the control signal and the black wire is for ground.
3. When using the Takyon Z14120 together with the DJI N3 or A3 ight
controller, connect the data cable (JST 3-pin) to the iESC port on the
flight controller via a smart ESC communication cable for redundant
throttle signal transmission.
4. Connect the motor to the ESC.
* Use a PDB which has sufcient trace spacing and current capacity, according
to the number of ESCs and the battery voltage.
7
1
2
3
4
5
6
Data Cable
Signal Cable
Power Cables Motor Cables
1. GND
2. Control Signal
3. GND
4. S+
5. S
-
6. Positive Power Cable (Gray)
7. Negtive Power Cable (Black)
ESC Cable Layout
Loading ...
Loading ...
Loading ...