Loading ...
Loading ...
Loading ...
10
INHALER ASSEMBLY & USE
1. Make sure Mist Chamber is removed from the base and fill the base with cool water only
to just below the max indicator.
DO NOT fill water all the way to the rim.
DO NOT add any medication, essential oils, or salt to the water.
DO NOT use the inhaler without the Inhaler Hood in place. Steam may cause burns.
2. Place the Vent Assembly securely onto the base. The power will not turn on if the Vent
Assembly is not properly placed on the base.
3. Attach the Inhaler Mask by lining up the triangular notch on the mask with the triangular
notch on the front of the fent assembly. DO NOT USE WITHOUT MASK ATTACHED.
4. Plug the power cord into a wall socket and press the power button. The power light will
illuminate the mist icon in green when powered on. Note: It will take 3-5 minutes for the
water to heat & mist to begin to rise.
5. Always begin with the vent levers at minimum (all the way to the left). Rest your face
gently on the mask. Do not press hard as the soft plastic may bend allowing steam to
escape or the inhaler to tip & spill boiling water.
ADJUST THE MIST INTENSITY: by sliding the Vent Lever clockwise to allow more steam/increase
the temperature or counterclockwise for lower steam flow/lower temperature. If the steam is
still uncomfortably warm, lift your face 1-2 inches above the mask. Breathe normally through
your nose and mouth, inhaling steam into your nasal and throat passages.
6. When desired vapor treatment is complete, press the power button to turn off.
Note: After 20 minutes the unit will automatically shut off to indicaate the end of a full
treatment cycle. For another 20 minute treatment cycle, press the power button to start
again. When finished with use, disconnect the plug from the outlet and allow time to
cool before moving or refilling.
7. When the base runs out of water, the power light will illuminate red and mist output will
stop as a safety feature. Turn the power off, unplug and allow time to cool before
refilling the base. Make sure to use two hands to remove the vent assembly. Do not
remove vent assembly by lifting from the inhaler mask
NOTE: The vent assembly has 2 slots one on each side which can be used with compatible
scent pads. Please note at this time Crane does not make crane scent pads.
IHALER MAINTENANCE
AFTER EACH USE
1. Remove Inhaler Mask and Vent Assembly by lifting vent assembly with two hands..
Wipe both parts dry with a clean cloth.
2. If any water is left in the base, empty and wipe base dry with a clean cloth.
NEVER IMMERSE BASE IN WATER.
WEEKLY MAINTENANCE
If your Inhaler is used 10 or more times a week (or scale builds up in the base) follow the
weekly maintenance for the humidifier base on page 9.
1. Wash the Inhaler Mask with mild soap and warm water. Carefully rinse with fresh,
clean water to remove soap and dry with a clean cloth.
2. Wipe the Vent assembly dry with a clean cloth.
WHEN STORING HUMIDIFIER OR INHALER, LET ALL PARTS DRY COMPLETELY BEFORE
STORING AWAY IN A COOL, DRY PLACE UNTIL NEXT USE.
Loading ...
Loading ...
Loading ...