Loading ...
Loading ...
Loading ...
Instruction For Use
(2) Measurement process
(1) Installing the product
(3) Power o
(4) Unit switching
(6) Replacing batteries
(5) Installing and replacing batteries
1
2
3
≤1.18in(3cm)
4 5
Expected use and scope of applications
Contraindications
This product mainly uses IR temperature sensing of the
forehead to measure human body temperature. Can be used
for babies, children, and adults. Babies and children should
not operate the thermometer on their own. Body temperature
readings for babies and children should be taken by an adult.
Reminder: Temperature readings may dier according to skin
tone and measurement distance.
Insert the 2 battery cells from the packaging box into the
battery compartment at the back of the device. The product
will start automatic inspection and a standby mode (if the
device indicates low battery power, then replace the
batteries to ensure ample power supply).
The patient is an intended operator. The patient can measure,
transmit data and change battery.
If no more measuring is required, simply let the device sit idle
for 8 seconds to power o automatically.
When switched ON for use, the thermometer will
automatically detect remaining battery capacity. If battery
capacity is low but adequate for measurements, the low
power symbol [ ] will be displayed with the measurement
results. However, if the battery capacity is too low for
measurements, the screen will display a single, ashing [ ]
icon and automatically switch OFF after 8 seconds. To
continue using the device, old batteries must be replaced.
1. Press down and hold the battery cover with the nger and
apply some force to slide the cover backwards to open the
battery compartment.
2. Remove the old batteries and install the new batteries.
3. Refer to the battery polarity symbols to orient the batteries
properly during installation. Make sure that the new
batteries are tightly inserted into the battery compartment
and make sure that the polarity is not reversed during
installation.
4. Return the battery cover to close the battery compartment.
Comply with relevant national laws and regulations when
disposing of the used batteries.
Do not dispose of batteries directly into the trash bag.
Remove the batteries if the device will not be used more
than one month.
Reminder: If you do not press and hold the measurement
button for 8 seconds to conrm the unit selected before the
screen switches o, the system will consider the switch as a
failure and retain the original unit for temperature
measurements.
1. When the device is powered OFF, press and hold the
measurement button for 8 seconds to enter unit switching
mode. Under this mode, both ℃ and °F should ash at the
same time.
2. Under this mode, press the measurement button to switch
to Fahrenheit or Celsius. The corresponding symbol of the
selected unit after switching will ash.
3. After selecting the unit, press and hold the measurement
button for 8 seconds to leave the unit switching mode.
Aim the thermometer probe at the center of the
forehead and keep the probe 1.18in (3cm) away from
the forehead (the optimal distance is about the width of
an adult’s index nger). Do not touch the forehead with
the probe.
Gently press the
measurement button
[ ] to start the
measurement.
The device will vibrate
once a reading is obtained.
The reading will be
displayed on the screen. If
the measurement is failed,
the device will not vibrate
the screen but display
[ ] instead.
A. Measurement distance is greater than
1.18in (3cm);
B. Environment temperature does not
meet measurement requirements or
there is an excessively large
temperature dierence;
C. Target temperature exceeds
measurement range.
Possible reasons for measurement errors include:
It is not recommended for people whose measuring part has
local lesions, such as inammation, trauma, postoperative,
etc.
Loading ...
Loading ...
Loading ...