Loading ...
Loading ...
Loading ...
Assembly / Owner’s Manual
42
Results
When a workout ends, the Console will show your workout results. They are shown in sequence (time, distance, calories, average heart rate, and aver-
age speed) three times.
Console Service / Setup Mode
The Console has a Service / Setup Mode. Some options in the Service / Setup Mode can be adjusted to your preferences, but most are helpful for
service of the machine. To access the Service / Setup Mode, hold down the Increase and Decrease buttons for 2 seconds when in Idle Mode.
Order Display Option Description
1 Unit Units Select your preferred unit of measurement; “Lb” = English Imperial, “SI” = metric
2 brt Brightness Control the brightness level of the Console; “20” = maximum intensity, “1” = minimum
3 LOG Error Log * Displays error codes, starting with the most recent
4 Con Console Version * Displays the Console software version
5 dr Drive Version * Displays the drive software version
6 HrS Total Hours Displays total number of hours and minutes used
7 diSt Total Distance Displays total distance
8 HiSt Motor Current History * Displays the average motor current for the current maintenance interval. Push the Decrease
button to view the averages of previous intervals.
9 Hd Hardware Type * Displays the hardware type
10 Curr Motor Current * Displays the current of the motor
11 CoAS Coast Time * Tests to see how fast the the belts stop
12 LOOP Loop Back * Test to see if the Console is receiving data
13 Str Set Time Reference Sets the current day and time as the start of the workout week for all users
14 CSn Console Serial Number
*
Displays the serial number for the Console
15 dSn Drive Serial Number * Displays the serial number for the Motor Control Board
16 dES Drive Error Statistics * Displays the hard fault statistics experienced by the Console
17 Prog Program Drive * Updates the program of the USB Drive
18 USb Write System Log * Saves the system log to an attached USB Drive
* for Service Technicians
Use the Increase and Decrease buttons to cycle through the Options. To change the value of an Option, push START and use the Increase and
Decrease buttons to select the new value. Push START to assign the new value to the Option.
Push STOP to exit an Option and the Service / Setup Mode.
Loading ...
Loading ...
Loading ...