Loading ...
Loading ...
Loading ...
5
SAFETY AND WARNINGS
Positioning inside the cabinetry
z
Ensure the door of the appliance is closed when rolling into thecabinetry.
z
Ensure the power cord is not run over or damaged when rolling the product into
the cabinetry.
Aligning inside the cabinetry
z
For flush installation, ensure the door panels are installed flush with cabinetry front surface.
Ensure the appliance is properly is centred.
z
All four corners of the appliance must be supported firmly on the floor to eliminate any
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Fixing inside the cabinetry
z
Use low speed, low torque setting when using a powered driver for the screws when fixing
or aligning the product.
z
Make sure to remove the depth alignment brackets before fixing theappliance inside the
cabinetry.
z
Open the appliance door to remove the alignment brackets from both sides of the
appliance, and then re-tighten the screws.
Installing the door panel
Stainless steel panel
z
Protect the finish of the Fisher & Paykel Stainless Steel door panels from any scratch
or damage.
z
Remove the blue tape attached to inner edges of the door panels after the handles are
installed.
z
We recommend to load the shelves in the appliance door with weights to ensure an
accurate door panel gap width.
Custom panel
z
If using Custom door panels, ensure they are prepared as per 'Custom door panel install
dimensions' section.
z
The thickness of the custom door panel can vary as long as the screws do not penetrate
beyond the full depth of the door panel, and as long as the overall weight of the panel
does not exceed 55lb/25kg.
z
Do not place the handle holes in marked areas to avoid clashing with panel
attachment brackets.
z
Minimum panel thickness where screw hole is drilled must be 16mm.
Switching the door hinge (optional)
z
Door hinges are interchangeable for each model. A hinge change kit is available and can be
purchased separately if you prefer to change from ‘right hand hinge’ to ‘left hand hinge’ or
vice versa.
INTEGRATED COLUMNS — REFRIGERATOR–FREEZER
24” (610mm) 30” (762mm)
RS2484WR
RS3084WR
RS2484WL
RS3084WL
Loading ...
Loading ...
Loading ...