Loading ...
Loading ...
Loading ...
EN
©2020 Hestan Commercial Corporation
6
INSTALLATION
ANTI-TIP BRACKETSANTI-TIP BRACKETS
Unit may tip forward if loaded racks/shelves are all pulled out at the same time. To prevent tipping,
and to provide stable installation, the unit must be secured in place with the anti-tip brackets
supplied with the unit. The anti-tip brackets, when properly installed, should secure the rear legs/
glides to the mounting surface and prevent the unit from tipping forward.
NOTE: Anti-tip brackets are only used for stationary cabinets and should not be installed on
cabinets with accessory casters. Caster kits are available for Hestan models. Refer to the instructions
supplied with the caster kit for proper installation.
Note: If installing on a concrete floor, concrete fasteners are required and not included with the anti-
tip kit.
Note: Some installation sites may require modifications to provide a secure surface for attaching the
brackets.
A set of anti-tip brackets is supplied with the unit. These brackets should be attached to the floor at
the rear of the unit. Each bracket must be located to engage the rear legs when the cabinet is pushed
back into position. Refer to Figure 1 (shown below) for anti-tip bracket mounting locations.
PREPARING THE SPACEPREPARING THE SPACE
If the unit is to be installed under a countertop, it is recommended that the countertop be supported
by a structure other than the unit itself to prevent damage to the unit.
Make sure the floor under the unit is level with the surrounding finished floor. Protect a finished
floor with plywood, cardboard, or some other suitable material before moving the unit into place.
Failure to do this may result in damage to the floor.
Figure 1. 24” Anti-Tip Kit
15
⁄16”
3
⁄16”
22-
3
⁄16”
BRACKETS
Loading ...
Loading ...
Loading ...