Loading ...
Loading ...
Loading ...
25
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The handle is not in
position.
Carriage bolts are not seated
properly.
Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Cam handle is not tightened. Tighten cam handle.
The mower does not start.
The extension cord is not
connected to the mower plug.
Reconnect the cord, and use the
cord restraint to keep the cord close
to the switch.
The extension cord is not
connected to the power source.
Connect the extension cord to a live
120V AC, 60 HZ AC receptacle.
The control switch is defective.
Have motor control switch replaced
by an authorized service center.
The mower cuts the grass
unevenly.
The lawn is rough or uneven. Check the mowing area.
The cutting height is not set
properly.
Move the wheels to a higher
position.
The mower is not mulching
properly.
Wet grass clippings are sticking
to the underside of the deck.
Wait until the grass dries before
mowing.
The mower is hard to
push.
The grass is long, or the cutting
height is too low.
Raise the cutting height.
The rear of the mower housing
and the blade are dragging in
heavy grass.
The mower vibrates at
higher speed.
The motor shaft is bent.
Stop the motor, disconnect the
mower from the power source,
and inspect it for damage. Repair
the mower before restarting. If the
vibration persists, call the toll-free
helpline, at 1-888-909-6757.
The blade is unbalanced.
Balance the blade by grinding each
cutting edge equally.
Loading ...
Loading ...
Loading ...