User Manual GL-0801A ILve Cars

Documents for ILve GL-0801A

The following documents are available:
User Manual Photos
GL-0801A photo
Digital Tire Pressure Gauge Manual
Thank you for purchasing the 150 PSI Tire Pressure Gauge from AstroAI. For optimal
performance and safety, please read and follow all of the instructions below before operating
the device. Please keep this manual for future reference. We hope you enjoy your new Tire
Gauge!
WARNING
Do not use this product for applications outside of its intended use
Read and follow all instructions before use
DIAGRAM
1. LED Light
2. Nozzle
3. Trigger
4. LCD Backlit Screen
5. Handle
INSTRUCTIONS
1. Press the trigger to turn the tire pressure gauge on. The gauge will display “0.0” on the
LCD Screen.
2. Place the nozzle of the tire pressure gauge on the tire valve you wish to measure. Press
firmly to ensure a good seal and prevent air from escaping.
3. Hold the gauge on the valve until the measurement display locks. It should only take a
second if you have a good seal.
4. Remove the gauge to easily read the pressure reading.
5. To change units, simply press the trigger to rotate through the four available pressure
units.
6. Tire pressure gauge will automatically turn off shortly after use. Manually turn off the
gauge by pressing and holding the trigger.
CHANGING THE BATTERY
1. Locate the screws on the back of the tire pressure gauge.
2. Use a small phillips screwdriver to remove the screws and back cover.
3. Locate the 3V battery, remove it from its place and replace it with a new battery.
4. Take special care to place the battery with the correct polarity.
5. Replace the back cover and screws.
SPECIFICATIONS
Range: 0-150 PSI / 0-10 Bar / 0-10 Kgf/cm
2
/ 0-1000 Kpa
Display: 21 x 10mm LCD display
Power: 3V Lithium coin cell
Operating Temperature: -5~50°C / 23~122°F
Loading ...