Loading ...
Loading ...
Loading ...
www.PyleUSA.com
4
Press open the AMP terminals on the control center, then insert your receiver/ampli-
er's positive (+) wires into the positive (red) terminals, and negative (-) wires in the
nagative (black) terminals. Then press the tabs to close them.
Notes:
• If your receiver/amplier has more than one set of speaker terminal (A and B),
connect only one or the other to the control center.
• For the best results, we recommend 14-gauge, two conductor speaker wire (not
supplied) for most connections. If you plan to located the speakers further than 80
feet from the control center, use a heavier gauge of wire.
OPERATION
Cautions:
• To avoid damaging your receiver/amplier, set its volume to the lowest setting
before changing the control center's settings.
• To turn on a pair of speakers connected to the control center, simply press in the
desired button. For example, to turn on the set of speakers connected to SPKA,
press A.
• To turn o a pair of speakers, press the button again so it is in the "out" position.
Note:
If no speakers are connected to a set of terminals, do not press in the corresponding
control button.
IMPEDANCE CHART
Impedance is a measurement of the load placed on your receiver/amplier by the
speakers. The load placed on your receiver/amplier from the control center will vary
depending on how many pairs of speakers you turn ON at one time, and on which
speakers you turn ON. The chart below shows the impedance for all possible
combinations of 8-ohm speakers.
Loading ...
Loading ...
Loading ...