Frigidaire FSC23R5DSW 22.6 Cu. Ft. Counter-depth Side-by-side Refrigerator

If you just installed your refrigerator, it is connected to a water supply so it can produce ice and dispenser water. However, air can be trapped in the new plumbing lines which can result in 2 or 3 empty ice maker cycles. Furthermore, if the system is not flushed, the first ice cubes may be discolored or have an odd flavor. It will also prohibit the water to evenly flow initially from the dispenser. To prime the water supply system, do the following:

Begin filling the system by pressing and holding a drinking glass or pitcher against the water dispenser paddle.
Keep the glass or pitcher in this position until the water comes out of the dispenser. It may take about 1-2 minutes.
Continue dispensing water for several minutes to flush the system and plumbing connections of any impurities.
Discard the water and repeat this process a few more times.
If you have any questions, please contact us.

In general, you should change your water filter every six months to ensure the highest possible water quality.

On most models, the Water Filter Status on your display will illuminate and prompt you when it’s time to replace the filter. If your refrigerator has not been used for a period of time (during moving for example), it is recommended to change the filter before reinstalling the refrigerator.

To order replacement filters, simply go to our Filter & Parts page. Remember to order the same filter type that is currently in your refrigerator.

If you need more help, please contact us.

Depending on your model, there are various features and functions available on your Side-by-Side refrigerator. It is always recommended to check out your Owner’s Manual for more descriptions of these features.

Press OPTIONS to illuminate the center of your display – this will show you the available features and functions.

Use the UP or DOWN key to scroll through the menu that appears in the center of your display.

To change a setting to ON or OFF, press the +; then press SET to select. When selection is made, go back and press OPTIONS to save.