Loading ...
Loading ...
Loading ...
E9
For questions or support, please visit www.sunbeam.ca.
Preheat Feature (selected models only):
The preheat function will heat the bed for a period of 30 minutes and the control will return to its original
setting.
1 To use the preheat feature, simply turn on the warming product by pressing the “On/Off” button and
then press the “Preheat” button. The display will show “PH” while the function is activated.
2 To reset the preheat feature, simply turn off the control by pressing the “On/Off” button and then turn it
back on by pressing the “On/Off” button.
Using Your Control:
1 To turn the control on, press the “On/Off” button.
Note: For SelectTouch™ and SleekSet™ controls, the backlit display light will reset itself by flashing “88”
and then will return to the previous setting and will begin to warm.
2 Note: For OneSet™ control, press the button to turn on to the lowest heat setting. Repeat pressing the
button to scroll to desired heat setting (5 total). To turn off, scroll through heat settings until all LED
indicator lights turn off.
3 Adjust the warming setting to your personal comfort by rotating the top knob left or right for
EasySet
™
controls.
4 Note: For SelectTouch
™
controls, press the large left button with the “-” sign to lower the heat setting
and the large right button with the “+” sign to increase your heat setting.
5 Note: For SleekSet™ controls press the upper button with the up arrow to increase your heat setting and
the lower button with the down arrow to lower the heat setting
6 To turn the heated blanket/mattress pad OFF, press the “On/Off” button.
CAUTION: ALWAYS turn the heated blanket/mattress pad “OFF” when not in use.
DesignSmart™ Controller
Selectable Auto Off:
You can set the auto-off time at 2hrs, 6hrs or 10hrs.
1 To use the auto-off feature, Press the Mode button until the “Auto-Off” words begin to flash.
2 While the “auto-off” is flashing, use the + (dimmer increase) and - (dimmer decrease) buttons to scroll
through the 3 auto off options.
Auto off will be set at the highlighted time. (The control will remember the auto off setting unless AC power is
disconnected.
If no button is pressed after 6 seconds, the highlighted setting will be set.
Preheat:
The preheat function will heat the bed for a period of 30 minutes and the control will return to its original
setting.
1 Press the mode button until “Preheat” appears on the screen. The preheat will then start.
2 To turn off the Preheat feature press the mode button until the “Preheat” disappears from the screen or
press the On/Off button to power off the unit.
Heat Adjustment:
There are 10 settings from Low to Hi.
To adjust the heat setting, simply press the + (raise heat temp) or the – (lower heat temp) on the large
circular button in the center of the control.
Dimmer:
Your controller gives you the ability to adjust the brightness of the display.
To adjust the brightness, Press the + (dimmer increase) or the – (dimmer decrease) buttons to change the
brightness level.
Loading ...
Loading ...
Loading ...