Loading ...
Loading ...
Loading ...
20
Cleaning and care
-Wipe the control panel with a clean, soft cloth.
interior
appliance
(including exterior and interior accessories)
be
cleaning.
Danger of electrical shock! Before cleaning
switch the appliance off and remove the plug
your
-Spray water onto the cleaning cloth instead
even
cabinet
-Don't use sharp objects as they are likely to
solvent such as Benzene for cleaning. They
regularly. It will be easier to clean when food
stocks are low. Wipe the inside of the fridge
freezer with a weak solution of bicarbonate
completely dry before replacing the shelves
Thoroughly dry all surfaces and removable
should be cleaned regularly at least every
ethereal oil, abrasive cleansers or organic
may damage the surface of the appliance
using a wrung-out sponge or cloth. Wipe
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
choose a time when the supply of food
stocks are low and proceed as follows:
not
of
appliance, you should clean it regularly.
of spraying directly on the surface of the
surfaces with a mild detergent and then
-Don't use thinner, car detergent, clorox,
of soda, and then rinse with warm water
open too long. If the frost is too thick,
an
distribution of moisture to the surface.
appliance
Although this appliance automatically
must
and
during
appearance
ensure
the
handles
appliance
mains
wiped dry with a soft cloth.
reasons
helps
the
from the mains socket.
2. When defrosting is completed, clean your
freezer as described above.
Caution! Don't use sharp objects to remove
frost from the freezer compartment. Only
after the interior is completely dry should the
appliance be switched back on and plugged
back into the mains socket.
Gasket cleaning
Take care to keep gaskets clean. Sticky
food and drinks can cause gaskets to stick to
the cabinet and tear when you open the
door. Wash gaskets with a mild detergent and
warm water. Rinse and dry it thoroughly after
cleaning.
Caution! Only after the gaskets are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning:
The LED light should be replaced by a
competent person. If the LED light is
damaged, contact the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing
the connector latch.
4. Replace LED light and snap it
correctly in place.
Ventilate the room thoroughly to accelerate
1.Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors open.
the thawing process.
good
doors,
scratch the surface.
and may cause fire.
clean
the
Exterior cleaning
The
This
Interior cleaning
hygienic
to
maintain
and baskets.
two months.
the
should
Caution!
connected
appliance.
-
Clean
Caution!
parts.
For
T
o
You
Loading ...
Loading ...
Loading ...