Loading ...
Loading ...
Loading ...
Cybex Arc Trainer 750A/750AT Owner’s Manual
33
Testing Operation
Use the following instructions to test the full resistance and incline range of the unit:
Plug the optional power cord into a power outlet from a grounded circuit. See 1. Electrical
Requirements in this chapter. NOTE: Coil up the remainder of the power cord and place it out of
the way.
Verify the control panel will illuminate and is in 2. Dormant Mode when using the optional power
adapter.
NOTE: If not using the optional AC power kit, the display will not illuminate until step 4.
Hold the handrails to steady self while stepping into the foot plates.3.
Begin striding.4.
Verify lower heart rate cable is not rubbing on handle during operation.5.
Press the QUICK START key.
Run unit through full resistance range. First press the 6. RESISTANCE + key until unit reaches its
highest load (the display will show “100”). Then press the RESISTANCE - key until unit reaches its
lowest load (the display will show “0”).
NOTE: When unit reaches the set incline and resistance, the displays will stop ashing and remain
steadily illuminated to indicate the desired settings have been reached.
Run unit through full incline range. First press the 7. INCLINE key until the unit reaches its highest
incline (the display will show “20”). Then press the INCLINE key until unit reaches its lowest
incline (the display will show “0”).
WARNING: Wait until all moving parts come to a complete stop before dismounting.
Press PAUSE/END twice to bring the incline back to its start position, end the workout review, and 8.
return the display to Dormant Mode.
Wait until foot plates come to a complete stop before dismounting unit. Hold handrails to steady 9.
self while stepping off unit.
Loading ...
Loading ...
Loading ...