Loading ...
Loading ...
Loading ...
Getting to know your appliance en
9
Adjusting the bypass
If necessary, use a Torx screwdriver to adjust the
bypass screws (M):
A: For ULPG the bypass screws must be tightened
properly.
B: For Natural Gas the bypass screws must finish flush
with the fitting.
Make sure that the flame does not go out and that there
are no flashbacks when you turn the control knob
between the highest and lowest setting.
Fitting the plug-in board and cover:
Work backwards through the instructions for removing
the plug-in board and cover.
Calibrating the electronics
As soon as the new appliance has been installed,
calibrate the electronics in accordance with the figure.
Never remove the gas valve shaft. In the event of
damage, the gas valve must be completely replaced.
*Getting to know your
appliance
Getting to know your appliance
Burner locations
! Pan supports
" Control knobs
# Economy burner with an output of up to 1 kW
$ Standard-output burner with an output of up to
1.75 kW
% High-output burner with an output of up to 3 kW
& Dual-wok burner with an output of up to 5 kW
Controls and burners
Each control knob is marked with the burner it controls.
You can use the control knobs to set the output
required in each case to various positions between the
maximum and the minimum settings. Never try to switch
directly from position 0 to position 1 or from position 1
to position 0.
$%
V
V
Indicators
¢
Burner controlled by control knob
Û
Switched-off burner
9 Highest power setting and electric ignition
1 Lowest power setting
Displays
³
Electric ignition
Š-‚
Heat settings
‹
Switched-off burner
•-œ
Residual heat
7'$1$
2
1
k
k
k
k
k
k
k
Loading ...
Loading ...
Loading ...