Loading ...
Loading ...
Loading ...
6
NOTE:
● The water valve is equipped with two strainers: a plastic basket type and a wire mesh screen.
Turn off the water (the local water service center should be able to provide this service), and
disassemble the water valve when cleaning both strainers. Consider installing a second water
strainer in the water line if local water conditions require periodic cleaning, or if using a well as a
water source. Obtain a water strainer from a local appliance dealer, if needed.
● DO NOT USE PIERCING-TYPE OR 3/16” SHUT-OFF VALVES. They reduce flow of water to the
in-cabinet icemaker and are easily clogged.
● CUSTOMER INSTALLATION IS NOT WARRANTED BY THE ICEMAKER MANUFACTURER
Reversing the Door Swing of the Icemaker
This appliance has the capability of the door opening from either the left or right side. The appliance is
delivered with the door opening from the left side. Please follow the instructions below to reverse the
opening side of the door. To make the reversal, you will find two hardware pieces in a plastic bag inside
the appliance: the top left hinge and the bottom left hinge. The bottom support bracket is used for both
sides.
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
2. Using a Philips screwdriver, remove the two screws and bottom right hinge beneath the door. Keep
the hinge in a safe place in case you need to reverse the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Interchange the plastic shaft sleeves at the top of the door.
5. Remove the bottom support bracket from the right side.
6. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the
future.
7. Remove the screws from the top left and transfer to the right.
8. Install the top left hinge.
9. Install the bottom left hinge to the door. Do not over-tighten the screws.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket.
12. Adjust door alignment. When set, tighten the hinge screws.
13. Remove handle. Transfer the screw hole covers to the left and install the handle on the right.
Loading ...
Loading ...
Loading ...