Loading ...
Loading ...
Loading ...
BEFORE USE
1. Remove all the packaging; take out the ice scoop and silicon plug.
2. Place the appliance on a stable and flat surface. Keep the appliance away from
heat sources and direct sunlight; keep it in a well-ventilated place and leave at
least 20cm/8” space near the air inlet and outlet.
3. Clean the appliance and its components (See “CLEANING AND MAINTENANCE”)
CAUTION: Do not use outdoors. Do not use the appliance in a too cold or too hot an
environment. When the environment temperature is lower than 5˚C/41˚F
or higher than 43˚C/109˚F, the appliance will have problems in making ice.
HOW TO USE
Do not use the appliance within 30 minutes after transportation. Switching on the
power too early might cause damage to your ice maker.
1. Take out the ice cube bucket. Pour potable water (only water conforming to
drinking standards) into the water tank. Pay attention that the water line should
never be beneath the “H-MIN” mark nor exceed the “H-MAX” mark. Place back the
ice cube bucket once water has been poured.
2. Put the plug into the power outlet. There is a beeping sound and the LCD display
will light up. Now the appliance is ready for use.
3. Press the “SELECT” button to choose the size of ice cube. Dierent sizes will take
dierent amounts of time. The default size is Medium.
S = Small (this will take approximately 9 minutes)
M = Medium (this will take approximately 11 minutes)
L = Large (this will take approximately 13 minutes)
4. Press the button to start making ice. The LCD display will have the snow flake
icon flashing to indicate the ice making process is on-going. You can press at
any time to stop the ice-making. The program will stop at once and you may find
some incomplete ice cubes.
5. After about 9-13 minutes (depending on the cube size), the first batch of 9
ice cubes will drop into the ice cube bucket. You can also check through the
transparent window on the top.
NOTE: The produced ice cubes in the bucket will
melt gradually so please use the scoop to
take out the ice cubes in timely fashion.
The melted water will be collected into the
water tank. If you want to remove the leftover
water in water tank, screw o the little cap
(a) counterclockwise at the back of appliance
and take out the silicon plug (b) replace cap when done.
Page 9
SET UP & USE
Loading ...
Loading ...
Loading ...