Loading ...
Loading ...
Loading ...
17
INSTALLATION
EN
• No further backflow protection
required for connection to the wate
r
inlet.
Checking the Rubber Seal
Two rubber seals
a
are supplied with
the water supply hose. They are used to
prevent water leaks. Connection to taps
is sufficiently tight.
• Do not use mechanical devices such as
multi grips to tighten the water supply
hose. Ensure that the curved en
d of
t
he water supply hose is connected to
the appliance.
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw the supply hose connector onto
the water supply tap. Hand tighten only
with the aid of a soft cloth. Do not
overtighten the supply hose with any
mechanical device.
NOTE
• After connecting the water inlet hose
to the
water tap, turn on the water ta
p
to flush
out foreign subs
tances (dirt,
sa
nd, sawdust, and etc.) in the wa
ter
lines.
Let the water drain into a bucket,
and check the water temperature.
Connecting the Hose to the
Appliance
Screw the supply hose to the water inlet
valve on the back of the appliance.
•
Do not connect the ho
se to the hot
water
supply for models with one
water inlet. Connect to the cold wa
ter
su
pply only.
NOTE
• After completing connection, if water
leaks fro
m the hose, repeat the same
steps. Use the most conventional type
of tap for the water supply. In case that
the tap is square or too big, remove
the guide plate before insertin
g the
tap into
the adaptor.
•
Make sure that the hose should
not be
kinked or trapped.
Loading ...
Loading ...
Loading ...