Loading ...
Loading ...
2
INSTALLATION INSTRUCTIONS
Before Using Your Ice Maker
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
1 removable ice bin
1 plastic scoop
25 ft. hose
1 instruction manual
• CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours
to allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to
do so may adversely affect performance and the lifetime of the unit.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Ice Maker
• This appliance is designed to be either free-standing or built-in (fully recessed). If it is built-in, leave
at least 3/16” at both sides, 1/16” at the top and 2” at the rear. Be sure that airflow under the
appliance is not blocked.
• Place your ice maker on a floor that is strong enough to support the ice maker when it is fully loaded.
To level your ice maker, adjust the leg at the front of the unit.
• Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the outer surface of the unit and heat sources may increase electrical
consumption.
• It is recommended that this appliance always be operated in an ambient temperature of at least
60°F and under 85°F. The appliance may be exposed to lower or higher temperatures, but only for
short periods of time, and the temperature should never be below 45°F. Extremely cold ambient
temperatures may cause the ice maker not to perform properly.
• Avoid locating the ice maker in moist areas. Too much moisture in the air will cause frost to form
quickly on the evaporator, requiring more frequent defrosting of the ice maker.
• Plug the ice maker into an exclusive, properly-installed grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized SUMMIT products service center.
Electrical Connection
• This ice maker should be properly grounded for your safety. The power cord of this ice maker is
equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize
the possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
• Never use a two-prong grounding adapter.
• Never use an extension cord to connect power to the unit. Failure to follow these instructions can
result in fire or electrical shock.
• When a two-prong wall receptacle is encountered, contact a qualified electrician to have it replaced
with a 3-prong receptacle in accordance with applicable electrical codes.
• This ice maker requires a standard 115/120 volts AC, 60Hz electrical outlet with three-prong
ground. The appliance can resist temporary voltage fluctuations from -15 to +10%.
ELECTRICAL SHOCK HAZARD
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER
CORD IS DAMAGED, HAVE IT REPLACED THROUGH AN AUTHORIZED SUMMIT PRODUCTS SERVICE CENTER.
Loading ...
Loading ...
Loading ...