Loading ...
2
.
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts needed
■ A UL listed or CSA approved conduit connector
■ UL listed wire connects
Parts supplied
■ 2 - #8–14 x 1" screws
Check local codes. Check existing electrical supply. See
“Electrical Requirements.”
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ It is the installer’s responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located on the right-hand side
oven door trim.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
■ Recessed installation area must provide complete enclosure
around the recessed portion of the range.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Electrical supply junction box should be located on rear wall.
Bottom of junction box should be 30¾" (78.1 cm) max. from
top of countertop.
■ The anti-tip mounting screws must be installed. See “Install
Range” section.
■ The range should be located for convenient use in the kitchen.
■ To eliminate the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood or
microwave range hood combination that projects horizontally
a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
■ Range support slats must be solid, level and flush with bottom
of cabinet cutout. Floor must be able to support a weight of
225 lbs (102.0 kg).
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction and
Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured Home
Installations, ANSI A225.1/NFPA 501A or follow local codes.
Mobile home installations require:
■ When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing the
range is adequate as long as it conforms to the standards
listed above.
■ Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See “Electrical Connection” section.
Mounting
screw
Tip Over Hazard
A child or adult can tip the range and be killed.
Securely attach mounting screws to cabinet.
Reattach mounting screws if the range is moved.
See installation instructions for details.
Failure to follow these instructions can result in death or serious burns to children and adults.
Making sure the mounting screws are installed:
• Remove side trim from both sides of the range.
• Look for screws securely attached to cabinet.
• Replace side trim.
WARNING
■ Phillips screwdriver
■ Router
■ ¹⁄₂" router bit
■ Measuring tape
■ Level
Loading ...
Loading ...
Loading ...