Loading ...
Loading ...
Loading ...
en Basic settings
28
--------
To access the basic settings:
The hob must be off.
1. Switch on the hob.
2. Within ten seconds, touch and hold the t symbol for
approximately four seconds.
The first four displays provide product information.
Touch the settings area to view the individual
displays.
3. Touching the t symbol again takes you to the basic
settings.
™‚ and ‹ light up as a preset in the displays.
4. Touch the t symbol repeatedly until the required
function is displayed.
5. Then select the required setting from the settings
area.
6. Touch the t symbol for at least four seconds.
The settings have been saved.
Leaving the basic settings
Turn off the hob with the main switch.
™‚„
Configuring activation of the flexible cooking zone
‹ As two independent cooking zones.*
‚ As a single cooking zone.
™‹
Restore to standard settings
‹ Individual settings.*
‚ Restore factory settings.
*Factory setting
**The hob's maximum power output is shown on the rating plate.
Product information Display screen
After-sales service index (ASSI)
‹‚
Production number
”š
Production number 1
Š†.
Production number 2
‹.†
Energy consumption indicator en
29
[Energy consumption
indicator
Ener gy cons umpt i on i ndi c at or
This function indicates the total amount of energy
consumed by this hob the last time it was used for
cooking.
Once the hob is switched off, the energy consumption
is displayed in kilowatt hours (e.g.
‚.‹‰ kWh) for 10
seconds.
The accuracy of the information displayed depends on
the voltage quality of the mains power supply, among
other factors.
You can find out how to switch this function on in the
section on ~ "Basic settings"
tCookware check
Cook war e check
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1. Place a cold saucepan containing approx. 200 ml of
water in the centre of the hotplate the diameter of
which matches the base of the pan most closely.
2. Go to the basic settings and select the ™‚ ƒ setting.
3. Touch the control panel. A will flash on the hotplate
display.
The function has now been enabled.
After 20 seconds, the quality and speed of the cooking
process will appear in the hotplate display.
Check the result using the following table:
To reactivate this function, touch the settings range.
Notes
■ The flexible cooking zone only counts as a single
hotplate; place no more than one item of cookware
on it.
■ If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
■ You can find information on this function in the
section on ~ "Basic settings".
■ You can find information on the type, size and
positioning of the cookware in the sections on
~ "Induction cooking" and ~ "Flex Zone".
Result
‹
The cookware is not suitable for the hotplate and will therefore
not heat up.*
‚
The cookware is taking longer to heat up than expected and the
cooking process is not going as well as it should.*
ƒ
The cookware is heating up correctly and the cooking process
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
Loading ...
Loading ...
Loading ...