Loading ...
Loading ...
Loading ...
16
USE AND CARE INFORMATION
For Best Results
Start the rangehood several minutes before cooking to develop proper airow. Allow the rangehood to
operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Button Function Led
L Turns the lights on/off at maximum strength. -
Press and hold the button for approximately 2 seconds to turn the Dimmer Lights
On/Off.
-
T1 Turns the motor on/off at speed one. ON
Delay function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the Delay
function (automatic switching off of the Motor, the Fans and the Lighting with a 30
min. delay). Cannot be enabled when Intensive is on.
T2 Turns the Motor on at speed two. ON
Activated Charcoal Filter Alarm -
Press and hold the button for approximately 5 seconds, with all the hood turned off
(Motor and Lights), to turn the alarm on. The relevant LED ashes twice to conrm.
To turn the alarm off, press the button again and hold for at least 5 seconds. The
relevant LED ashes once.
T3 Turns the Motor on at speed three. ON
Press and hold the button for approximately 3 seconds, with all the hood turned off
(Motor and Lights), to perform a reset. The LED S1 ashes three times.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns
automatically to the speed that was set before. If it is activated with the motor turned
off, the hood will switch to OFF at the end of the time.
ON
Remote Control Activation
Press and hold for 5 seconds to enable the remote control, indicated by the LED
ashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED
ashing just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to
wash the lters. The alarm is triggered after the Hood has been in operation for 100
working hours. (Refer to Page 18 for Cleaning Filters and Reset of Filter Alarm)
ON
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
indicating that the lter must be changed; the Metal Grease Filters must also be
washed. The Activated Charcoal Filter saturation alarm comes into operation after
the Hood has been working for 200 hours. (Refer to Page 18 for Cleaning Filters
and Reset of Filter Alarm)
Flashing.
Loading ...
Loading ...
Loading ...