Loading ...
Loading ...
Loading ...
6
Cleaning with your spot cleaner
1. Plug unit in and turn on by pressing power
button under handle.
2. Hold cleaning tool approximately 2.5cm
above soiled surface. Press spray trigger to
apply cleaning solution to soiled area.
3. Using brush on cleaning tool, gently scrub
area to be cleaned.
4. For thorough cleaning, spray additional
solution while brush and suction are in
contact with surface.
5. Apply downward pressure on cleaning
tool and pull it toward you. The suction
will remove the dirt and cleaning solution.
Continue until no more dirt can be removed.
6. As a final step, use “drying strokes” (by
not pressing the spray trigger) to remove
as much liquid/moisture as possible. Repeat
this step as often as necessary.
7. When using Oxygen Boost formula, it will
continue to work for the next six to eight
hours cleaning your spots and stains all the
way to the backing of the carpet.
D
Care & Storage
Machine care
1. Unplug power cable from electrical socket.
2. Empty and rinse dirty water tank after
each use, OR when dirty water reaches
indicated maximum fill line.
a. Lift tank up and away from base
of machine.
b. Pull tab to remove plug from tank
c. Rinse out tank with clean water
after emptying.
d. Disconnect cleaning tool from hose
grip by pushing down on button lock
and pulling straight off. (Do NOT twist
cleaning tool to remove it).
e. The front nozzle of the small tough
stain tool can be removed for easy
cleaning. Push button at top of cleaning
tool and slide front nozzle off top of
cleaning tool. Rinse both with clean water
and replace front nozzle back on cleaning
tool. Rinse all other cleaning tools used
with clean water.
f. Check spray nozzle for accumulated
dirt or debris. If necessary, clean with
soft bristle brush.
g. The float stack can be removed from
inside dirty water tank for cleaning.
Turn locking assembly anti-clockwise
to unlock position and pull down and
out of tank to remove. Rinse with
clean water until all debris is removed.
Replace float stack back inside dirty
water tank and turn locking assembly
clockwise to lock position.
Machine storage
Water and cleaning formula can be left in
clean water tank for next use.
1. Wrap power cable around cable wrap
on back of machine.
2. Wrap hose around the base of unit and
secure the hose grip.
3. Store unit in protected, dry area, at room
temperature (4° to 43°C).
www.BISSELL.com
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical socket
before performing maintenance or care.
To reduce the risk of electric shock, always install
float stack before any wet pick-up operation.
Loading ...