Loading ...
Loading ...
Loading ...
12
First try the solutions suggested here to possibly avoid the cost of a service call.
If you experience
Possible Causes
Solution
TROUBLESHOOTING cont.
Cycle time too short
Automatic cycle ending early. The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the dryness level
setting setting on Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint on load
Lint screen clogged.
Lint screen should be cleaned before each load.
Stains on load or drum
Dryer fabric softener not properly
used.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled
Dryer tightly packed.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
Odors
Recently been painting, staining, or
varnishing in the area where your
dryer is located.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
Electric dryer being used for the rst
time.
The new electric heating element may have an odor. The odor
will be gone after the rst cycle.
Load is too hot
Laundry items removed from the
dryer before the end of the cycle.
Allow Cool Down cycle to nish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
High temperature cycle
used or was TEMPERATURE/Fabric
control set to high.
Select a lower temperature, and use an Automatic Dry cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Loading ...
Loading ...
Loading ...