Loading ...
Loading ...
Loading ...
Smoke alarms are designed to minimize nuisance alarms. Cigarette
smoke will not normally set off the alarm, unless the smoke is blown
directly into the alarm. Combustion particles from cooking may set off
the alarm if the alarm is located close to the cooking area. Large quanti-
ties of combustible particles are generated from spills or when broiling.
Using the fan on a range hood which vents to the outside (non-recircu-
lating type) will also help remove these combustible products from the
kitchen. If the alarm does sound, check for fires first. If a fire is discov-
ered, get out and call the fire department. If no fire is present, check to
see if one of the reasons listed in section 2 may have caused the alarm.
5. Nuisance Alarms
6. Maintenance
BATTERY REPLACEMENT
Note: Replacement batteries are available where you purchased your
alarm.
If tamper resist pin has been used, refer to TAMPER RESIST LOCKING PIN
in section 3 for removal instructions. To replace the battery, remove the
alarm from the mounting plate by rotating the alarm in the direction of
the “OFF” arrow on the cover (see FIGURE 8).
i9030, i9040, i9050, i9060 and i9080 Smoke Alarms are powered by a
9V carbon zinc battery (alkaline batteries may also be used). A fresh bat-
tery should last for one year under normal operating conditions. This
alarm has a low battery monitor circuit which will cause the alarm to
“chirp” Approximately every 30 - 40 seconds for a minimum of seven
(7) days when the battery gets low. Replace the battery when this condi-
tion occurs.
NOTE: ANY STATEMENTS REFERRING TO A BATTERY, APPLIES TO
BOTH BATTERIES USED WITH THE i9080
NOTE: DO NOT USE LITHIUM BATTERIES IN ANY OF THESE
MODELS.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM
BATTERY REPLACEMENT.
Carbon-zinc type: EVEREADY 1222; GOLD PEAK 1604P OR 1604S
Alkaline type: ENERGIZER 522; DURACELL MN1604, MX1604;
GOLD PEAK 1604A; PANASONIC 6AM6, 6AM-6,
6AM-6PI, 6AM6X, AND 6LR61(GA)
Models i9040RV and i9060RV are powered by a 9V alkaline battery. A fresh
battery should last for one year under normal operating conditions. This alarm
has a low battery monitor circuit which will cause the alarm to “chirp”
approximately every 30 - 40 seconds for a minimum of seven (7) days when
the battery gets low. Replace the battery when this condition occurs.
0930-7203-01(820-1493B)_EN_V1:_ 2014.7.24 2:15 PM Page 11
Loading ...
Loading ...
Loading ...