Loading ...
Loading ...
Loading ...
21
ge.com
Consumer Support
Operating InstructionsSafety Instructions Installation Instructions
Troubleshooting Tips
Burner Caps and Heads
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic scouring
pad to remove burned-on food particles.
Burner heads
For proper ignition, make sure the
small hole in the section that fits over the
electrode is kept open. A sewing needle
or wire twist-tie works well to unclog it.
The slits in the burner heads must be kept clean
at all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes
will not allow the burner to operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit an
electrode with anything hard or it could
be damaged.
You should clean the burner caps and
burner heads routinely, especially after bad
spillovers, which could clog the openings
in the burner heads. Lift off when cool.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20–30 minutes.
For more stubborn stains, use a toothbrush.
NOTE: Do not use steel wool or scouring powders
to clean the burners.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a warm oven
for 30 minutes.
Replacement
Replace the burner heads and caps. Make
sure that the heads and caps are replaced
in the correct location. There is one oval
(center) head and cap assembly and four
side heads and caps.
For model JGBS80:
For model JGBS09:
Make sure the slot in the burner head is
positioned over the electrode.
Make sure that the heads and caps are
replaced in the correct locations.
Medium burner
head and cap
Front of range
Large burner
head and cap
Small burner
head and cap
Extra large
burner head
and cap
Use a sewing needle or twist-tie
to unclog the small hole in the
burner head.
Oval head and cap
assembly
Slot
Electrode
Slot
Medium burner
head and cap
Front of range
Medium burner
head and cap
Medium burner
head and cap
Medium burner
head and cap
Oval head and cap
assembly
Loading ...
Loading ...
Loading ...