Loading ...
Loading ...
Loading ...
23
Notes
▯ If “ appears on the display, the sensor for the element
in question must be held down in order to be able to
read the fault code.
▯ If the fault code is not listed in the table, disconnect
the cooktop from the power supply, wait 30 seconds,
and then reconnect it again. If the display appears
again, contact Customer Support and tell them the
precise fault code.
▯ If a fault occurs, the appliance will not switch to
standby mode.
Suitability test of cookware
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
1.
With the cookware still cold, fill it with approx. 8 oz.
(200 ml) of water and place it on the center of the
cooking zone with the diameter that most closely
matches that of the base of the cookware.
2.
Go to the basic settings and select the ™‚ƒ setting.
3.
Touch the settings range. A will flash on the cooking
zone display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the cooking zone
display.
Check the result using the table below:
To reactivate this function, touch the settings range.
Notes
▯ The flexible cooking zone only counts as a single
element; place no more than one item of cookware on
it.
▯ If the diameter of the used cooking zone is much
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
▯ You can find information on this function in the section
~ "Basic settings"
▯ You can find information on the type, size and
positioning of the cookware in the sections
~ "Cooking with Induction" and ~ "FlexInduction
®
cooking zone"
“Š‹‚‚
The cooktop is not connected prop-
erly.
Disconnect the cooktop from the power supply.
Ensure that it has been connected in accordance
with the connection diagram.
š“
The demo mode is activated Disconnect the cooktop from the power supply.
Wait 30 seconds and reconnect it. Touch any
touch control in the next three minutes. The demo
mode is deactivated.
Display Possible cause Solution
Do not place hot pans on the control panel.
)OH[
-RLQ6SOLW
.HHS
:DUP
6SHHG
%RRVW
.LWFKHQ
7LPHU
&RRN
7LPHU
Result
‹
The cookware is not suitable for the element and
will therefore not heat up.*
‚
The cookware is taking longer to heat up than
expected and the cooking process is not going as
well as it ought to.*
ƒ
The cookware is heating up correctly and cooking
is progressing well.
* If there is a smaller element available, try the cook-
ware again on the smaller element.
Loading ...
Loading ...
Loading ...