Loading ...
5 INSTALL NEW ACCESS PANEL
ASSEMBLY AND TOEKICK
• Place the toekick against the bottom of the
dishwasher.
• Place the new access panel assembly
against the dishwasher and tighten the
attached screws.
• Re-install two original bottom screws
loosely. Adjust the toekick up or down and
tighten screws.
Pub. No. 31-30541 SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE DWG. NO. 206C1559P081
N.D. 923-13 2/04
4 CHECK DOOR BALANCE
• Open and close the door to check for proper
balance. Correct spring tension should
prevent the door from rising by itself from a
full open position and prevent the door
from falling heavily.
• If the door rises on its own, from a full open
position, decrease tension by moving one
or both springs forward.
3 ADJUST DOOR SPRINGS
• Grasp the end of the spring at the rear of
the dishwasher and release the hook.
• Release opposite end of the spring and
remove.
• Place the long end of the spring hook into
the link and place plastic link onto the
hinge arm hook.
• Stretch the short end of the spring and
hook into the 4
th
hole from the front of the
channel.
• Repeat the same procedure for the
opposite side.
2 INSTALL NEW DOOR PANEL
COVER
Note: The new door panel cover will com-
pletely cover the existing door. Do not
remove the original door panel.
• Tip door panel and slide up and under the
bottom and sides of escutcheon.
• Snap door panel over the door and slide
upwards, under the escutcheon.
• Drive 2 screws into the bottom of the panel
using a Phillips head screwdriver.
New Door
Panel Cover
Plastic
Link
Insert Spring Hook
Through Inside of Frame
Less Tension
Tighten 2 Screws
Loading ...
Loading ...