Loading ...
Loading ...
Loading ...
13
OPERATION
STARTING THE HEDGE TRIMMER (See Figure 3.)
1. Attach an extension cord to your hedger.
2. Place one hand on the trigger handle (1). Place the other hand on the auxiliary handle (2).
3. Slide the lock switch (4) backwards you then squeeze the trigger switch (3) to turn ON the
hedge trimmer. The trimmer will stay on as long as the trigger switch is squeezed. Lock-off
switch may be released once hedge trimmer is running.
STOPPING THE HEDGE TRIMMER (See Figure 3.)
1. Release the trigger switch (3).
2. Allow at least 5 seconds for the cutting blade to stop moving.
USING THE ROTATING REAR HANDLE(See Figure 4 )
1. Place the hedge trimmer on a at and even surface and disconnect from the power supply.
2. Make sure that you released the trigger.
3. Press the lock button and begin turning the rear handle. Release the lock button and turn the
handle 90 degrees to either side until it clicks into place and the button pops out.
4. To turn the handle back to center, press the lock button again, turn the handle slightly, release
the lock button and continue turning the handle until it locks into place.
Fig. 4
Lock button for
rotating handle
Loading ...
Loading ...
Loading ...