Loading ...
➔➔
➔➔
STEP 7: Mount the supplied L-bracket to the
driver’s side upper OEM woofer enclosure’s mount-
ing bolt hole (from STEP 4).Using the supplied
1/4” lock washer and 1/4” flat washer. Apply to the
factory moutning bolt that was removed from
STEP 4.
Using a 7/16” socket, securely tighten the bolt
assembly.
STEP 10: Place the Stealthbox into location.
Using the socket cup set screw as guide and place
through the drilled hole from STEP 6.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: Thread in the supplied socket cup set
screw into the Stealthbox, leaving about 1 3/4”
exposed. Make sure that the slotted end of the
threaded rod is exposed. Place the supplied spacer
onto socket cup screw.
Use a piece of tape to hold the spacer onto the
threaded rod.You can take off the tape, once the
Stealthbox is in lcoation.
STEP 11: While second person is holding the
Stealthbox into position (inside of vehicle). Place flat
washer, lock washer and nut onto the exposed
threaded rod and secure.
If the socket cup set screw does not have enough
length, back out the socket cup set screw from
inside of the Stealthbox.
Use silicon to weather proof the bolt assembly.
STEP 12: Use the supplied bolt, lock washer and
flat washer to secure driver’s side of the Stealthbox
to the L-bracket that was mounted in STEP 7.
STEP 9: Run speaker wire to the Stealthbox
location and attach to terminal.
*Check the woofer for proper operation.*
SB-H-ELMNT/10W3v2/BK, JL AUDIO, Inc 2003
Sheet SKU#011183 Revision 01/15/2004Page 2
www.jlaudio.com
➔
Loading ...