Loading ...
Loading ...
Loading ...
For bridged mode for a two-channel amplifier,
with a 4 W load, either wire two 8 W speakers
in parallel, Left + and Right * (Diagram A) or
use a single 4 W speaker. For other amplifiers,
please follow the speaker output connection
diagram for bridging shown on rear: two 8 W
speakers in parallel for a 4 W load or a single
4 W speaker per channel.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
! For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
CAUTION
Be sure to connect the subwoofer to the subwoo-
fer output terminal of this unit, and speakers
other than the subwoofer to the speaker output
terminal of this unit.
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W, or 4 W to 8 W for two-channel and other
bridge connections.
Subwoofer
! Nominal input:
Min. 350 W / 4 W
Min. 600 W / 2 W
Other than subwoofer (4 W)
Speaker channel Power
Four-channel output
Max. input:
Min. 150 W
Two-channel output
Max. input:
Min. 400 W
Connecting the car stereo
Connect the RCA output jack of the car stereo
to the RCA input jack of the amplifier, or con-
nect the speaker output wire from the car
stereo to the speaker input terminal of the am-
plifier.
CH-A input (Two-channel input)
! Slide the 2CH-4CH INPUT SELECT (input
select) switch to the 2CH position.
! Slide the A/B-SW INPUT SELECT (input se-
lect) switch to the A/B position.
2
3
5
4
1
1 2CH-4CH INPUT SELECT (input select) switch
(2CH position)
2 RCA input jack A
3 From car stereo (RCA output)
If only one input plug is used, e.g. when the
car stereo has only one output (RCA output),
connect the plug to RCA input jack A.
4 Connecting wires with RCA plugs (sold sepa-
rately)
5 A/B-SW INPUT SELECT (input select) switch
(A/B position)
Notes
! For details on the speaker output, refer to Con-
necting the speakers.
! When the 2CH-4CH INPUT SELECT (input se-
lect) switch is set to 2CH, do not connect any-
thing to RCA input jack B.
En
Connecting the units
Loading ...
Loading ...
Loading ...