Loading ...
Loading ...
Loading ...
Adjustments for Competition 113
Front Suspension Adjustments
(cont’d)
10. Extend the fork damper piston rod (6) to
maximum length, holding it, install the fork
cap assembly (5) to the fork damper (1).
Be careful not to damage the fork cap piston ring.
If it is difficult to install the fork cap assembly,
the fork damper oil level might be higher than
standard oil level.
(1)
(5)
(6)
(1) fork damper (6) fork damper piston rod
(5) fork cap assembly
(8) fork damper oil chamber (13) shop towel
13. Check the fork damper piston rod sliding
surface for damage.
14. Cover the fork damper piston rod end with
shop towel (13) to prevent fork damage.
Cover the oil holes with shop towel (13) to
prevent blow out of fork oil.
Blow the extra oil off from the fork damper
oil chamber (8) by pumping the fork damper
piston rod to full stroke.
Be careful not to bend or damage the fork
damper piston rod when the piston rod is stroked.
NOTICE
(6)
(12)
(8)
(13)
(13)
(1) fork damper (3) fork cap bolt holder, 36 mm
(5) fork cap assembly (4) lock nut wrench
12. Completely screw in the fork center bolt lock
nut (12) to the fork damper piston rod (6).
(1)
(4)
(5)
(3)
11. Place the fork damper (1) in a vise with a
piece of wood or soft jaws to avoid damage.
Tighten the fork cap assembly (5) using the
fork cap bolt holder, 36 mm (3) while holding
the cutout of the fork damper using the lock
nut wrench (4) to the specified torque:
22 Ibf·ft (30 N·m, 3.1 kgf·m)
• Fork cap bolt holder, 36 mm
070MB-MEN0100
• Lock nut wrench 07WMA-KZ30100
(6) fork damper piston rod (12) fork center bolt lock nut
Loading ...
Loading ...
Loading ...