Loading ...
Loading ...
Loading ...
18
Charging Protection LED Display
The table below shows battery protection mechanisms and corresponding Status LED patterns.
Battery Level Indicators for Battery Protection
LED1 LED2 LED3 LED4 Blinking Pattern Battery Protection Item
LED2 blinks twice
per second
Over current detected
LED2 blinks three
times per second
Short circuit detected
LED3 blinks twice
per second
Over charge detected
LED3 blinks three
times per second
Over-voltage charger detected
LED4 blinks twice
per second
Charging temperature is too
low (<0° C)
LED4 blinks three
times per second
Charging temperature is too
high (>40° C)
After any of the above-mentioned protection issues are resolved, press the Battery Level button
to turn off the Battery Level Indicator. Unplug the Intelligent Battery from the charger and plug
it back in to resume charging. Note that you do not need to unplug and plug the charger in the
event of a room temperature error. The charger will resume charging when the temperature falls
within the normal range.
DJI is not responsible for damage caused by third-party chargers.
Speaker Beeping Descriptions
Toggle the Speaker switch to turn the warning sound on or off.
Descriptions Beeping Pattern
Toggle the buzzer switch to turn it on Quick beeping
Connect to the Battery Charger Quick beeping
A battery pair is fully charged Quick beeping
Four Intelligent Batteries are fully charged
Alternating two short and one long beeps,
last for about 1 hour
Heating the Battery
Manual Heating: When the battery is powered off, press and hold the Power button for 3 seconds
to initiate battery warm-up manually.
The battery will warm up if the temperature is below 59° F (15° C). As it warms, Status LED 1 & 2
and LED 3 & 4 will blink alternately. The battery will stop warming when it reaches 68° F (20° C).
The temperature of the battery will remain between 59°- 68° F (15°-20° C). When Status LED 1 and
LED 4 blink alternately indicates a temperature above 59° F (15° C). This will last for approximately
30 minutes, then the battery will power off automatically.
Auto Heating: Insert the batteries into the Master Wheels and power on. When the temperature
of the battery is below 59° F (15° C), it will warm up automatically. Check the Status LEDs for the
current power level.
Loading ...
Loading ...
Loading ...