1. This kit contains the following parts and accessories.
2. Require tools
Screwdrivers, Nippers
3. Installation procedures
1) Install the air suction canvas
Tighten two fixing bolts for air suction canvas to the
indoor unit.
Fit the air suction canvas over the fixing bolts and
slide the direction of the arrow in Fig.2 to hang the air
suction canvas on the indoor unit.
Fit the remaining two fixing bolts and tighten all four
fixing bolts until the seal is about 3~5mm thick.
2) Adjust the air suction canvas height
Attach the suction outer grille. For details, see the
installation provided with the suction grille.
Hook the four adjusting chain over upper part of
suction canvas in Fig.3 (a).
Check the suitable point in the adjusting chain that
makes close the gap between the ceiling surface
and the suction grille.
Hook the four adjusting chain with checked point
over lower part of suction canvas in Fig.3 (b), cut
any extra adjusting chain with the nippers.
If you want more hard fixing, you can also use the
fixing screws for fixing adjusting chain with upper
and lower hook.(Fig.4)
Air suction canvas 1 1
Screws for air suction canvas 4 4
Adjusting chain 4 4
Screws for adjusting chain 8 8
Installation manual 1 1
Quantity
PBSC10 PBSC20
Name
Indoor unit
Air suction canvas
Fixing Bolt
M5 X 18
Fig.1
Fig.2
2
2
1
1
(a) Upper hook
Adjusting
chain
Additional
fixing hole
(b) Lower hook
Fig.3 Fig.4
ENGLISH
Suction Canvas Installation Manual(for Built-in duct suction grille)
