Loading ...
Loading ...
Loading ...
17
Using your humidifier
PLEASE READ THE ‘IMPORTANT SAFETY INSTRUCTIONS’ IN THIS DYSON
OPERATING MANUAL BEFORE PROCEEDING.
Introduction
• This is a cool mist, ultrasonic type of humidifier. Moist air is
directed into the room from the loop amplifier.
• Water passes over a UV-C emitter to ensure that it is 99.9%
bacteria-free before misting commences.
Location
• Always place the machine on a firm, flat, level surface.
• Do not place the machine on a rug, carpet, wooden flooring, or
any other surface that may be damaged by exposure to water
or moisture.
• It is recommended that a waterproof mat or pad is placed under
the machine.
• Do not place the machine underneath overhanging surfaces.
• Do not place the machine in an area where it is accessible
to children.
• Store the machine indoors. Do not use or store it below 41°F.
Ensure the machine is at room temperature before operating.
• For the best performance, place on the floor, in the corner of
the room, at least 1m from any wall and facing into the center of
the room.
Operation
• All parts must be securely fitted before use.
• Do not use the machine unless it has been cleaned according
to instructions.
• In humidifier mode do not use without water in the tank.
• Do not lubricate any part of this machine.
• When switched on, a small blue LED on the back of the machine
lights up to show that power is being received by the machine.
(Note: It does not mean that the machine itself is operating.)
• Once the water treatment cycle completes the machine is ready
to begin humidification.
Setting humidity level
• On first use, the display will show ‘70%’, which is the highest
relative humidity setting. The fan will run on lowest airspeed,
‘01’. For each use after this the machine will remember the last
target humidity level and airflow speed set.
• The machine will not operate unless the target humidity setting is
above the current room humidity level.
• The machine will automatically adjust to avoid
excessive humidity.
• Mist will be visible only in certain conditions (impacted by light,
background colour, etc.) or at the lowest settings.
Automatic mode
• Press the AUTO button on the remote. This is the recommended
mode of operation.
• The machine selects a comfortable humidity for the room, based
on environmental factors such as current humidity level and
air temperature.
• When the room reaches the appropriate humidity level the
machine will switch itself ‘ON’ or ‘OFF’ as necessary to maintain
that level. The fan will remain running when the target humidity
has been reached.
Manual mode
• Select the desired humidity level (from 30% to 70%). When the
room reaches the target humidity level the machine will switch
itself ‘ON’ or ‘OFF’ as necessary to maintain that level. The fan
will remain running when the target humidity has been reached.
Fan mode
• The fan mode button on the remote control turns the humidifier
mode ‘OFF’. Control the fan mode using the airflow and
timer buttons.
• No water is needed for the fan mode.
Control without remote
• Press the standby button on the machine to turn ON/OFF.
• Press and hold the power button on the machine to adjust the
humidity setting.
• Fan mode and the sleep timer cannot be operated without the
remote control.
• The air speed setting automatically sets to '05'.
Refilling
• When refilling, empty the tank completely (preferably washing
and drying it), then refill – this keeps the water fresh.
• With a full tank of cold tap water (3 liters) the machine will run
for at least 10 hours, depending on the target humidity setting
and other environmental conditions. Do not add anything to the
water ( such as scents, oils etc).
Cleaning the base
• Small water spillages may occur. While the amount of water in
the trough is not significant enough to damage the machine,
significant care should be taken when emptying it. Ensure that
water does not enter through the inlets of the machine. If some
water does pass through the inlets, dry the exterior with a cloth
and continue to use as normal.
Cleaning the tank
• Pour in the recommended citric acid solution. Replace the cap
and shake tank for 30 seconds. Then leave to stand. After
15 minutes, empty the tank. Rinse and wipe over all surfaces.
Repeat if necessary.
Storage
• When not in use, unplug from the mains electricity supply.
• Store the machine in a dry location and arrange the cable away
from traffic areas so that it will not be tripped over or damaged.
• Clean the machine and tank as instructed before storing and
before re-use.
Loading ...
Loading ...
Loading ...