Loading ...
Loading ...
Loading ...
7. Install eight Torx head screws securing top covers (front and back) to frame using a T25 Torx screwdriver.
QtyDescription
8Torx head screw1
2Top cover2
1Back panel3
Securely anchor machine to floor
Owner should not allow equipment to be used until it is properly anchored as described below.
Anchoring equipment:
• To maximize stability and eliminate rocking, tipping, or falling over, equipment
must be anchored to a solid, level surface, utilizing all anchoring holes provided.
• Fasteners must have a minimum of 500 lbs. tensile capacity. Cybex recommends
.3/8” grade 2 bolts or better. A minimum pull force of 220 lbs/100 kgs is required
for each anchor position.
• If leg frames do not contact surface, DO NOT pull down with anchors. Shim any
leg or frame not in contact with surface using flat washers.
• Due to the wide variation of flooring on which machines may be anchored or
installed, consult with a qualified and licensed contractor to ensure proper
anchoring and installation.
Verify proper operation
Page 17 of 25
Loading ...
Loading ...
Loading ...