Loading ...
Loading ...
Loading ...
Lower hinge heating control H
If condensed water appears in the
lower hinge area or on the base plate
between the refrigerator and freezer
compartments, increase the output of
the heating located behind the base
plate.
Factory default is HA.
Condensation does not occur at
normal room temperature and
humidity. The heating prevents
condensation at high humidity and
low room temperature.
Changing the heat setting
^ Press and hold the SuperCool button
for the freezer section On / Off button
for 5 seconds.
The SuperCool indicator ª to the right
of the display is on during this time, and
after 5 seconds S flashes in the lower
temperature display (freezer section).
The display shows MENU. You are now
in the settings mode.
^ Tap the button for setting the
temperature in the freezer section
until a flashing H appears in the lower
temperature display.
^ Touch the Super button again.
The following will appear in the display:
– HA: select this if there is only little
condensation,
– H1: select this if there is a lot of
condensation,
– H0: select this if there is no
condensation (heating off).
^ Change the heat setting by tapping
the button for setting the temperature
in the freezer section.
^ Touch the Super button again to
confirm your selection.
^ To leave the settings mode, touch the
button for turning the freezer section
on and off.
Additional Settings
29
Loading ...
Loading ...
Loading ...