EL1SS Telephone Entry System
Resident Guide
When You Answer the Visitor’s Call:
How a Visitor Contacts the Resident:
1
2
3
4 5 6
7 8
9
*
0
#
Lyl
War
1
2
3
4 5 6
7 8
9
*
0
#
Visitor gains entry
Visitor presses call button to
contact resident.
Resident answers the call. Resident grants access
by pressing *9 or *5 or denies access by simply
hanging up.
When a visitor presses the “CALL” button, the system rings your telephone.
When the home phone receives a call from the EL1SS,
answer the call to initiate the audio and to speak to
visitor. To deny the caller access to the property, hang
up. To extend the talk time press 0 or continue talking.
NOTE: The home phone is a phone wired directly to the
EL1SS system. To use a cell phone, see call forwarding
instructions on next page (not available in intercom
mode).
CALL WAITING (Single Family Residence ONLY):
Press “Flash” once to answer guest, press again to
return to outside call on telco line, if *9 or *5 is not
pressed. If *9 (relay 1) or *5 (relay 2) is pressed, the
EL1SS will automatically return to the telco line.
GRANTING ACCESS:
Press * 9 to grant access through the door or gate
connected to Relay 1. The call will end.
or
Press * 5 to grant access through the door or gate
connected to Relay 2. The call will end.
Using Entry Codes:
An Entry Code allows access by entering a numeric code on the EL1SS keypad.
Enter your assigned Entry Code for access (see chart below). If you make an error
while entering your code, press “*” to cancel.
12:00
AM
Dec. 31
MENU
REDIAL
TALK
OFF
FLASH
123
456
789
#
&’)
ABC
GHI JKL MON
PQRS TUV
WXYZ
OPER
DEF
0
Extend talk
time (also
activate
audio for call
forwarding
calls)
Hang up to
deny access
to the visitor
Toggle between visitor
and another phone call
Activate all entry
devices connected
To Relay 2
Activate all entry
devices connected
To Relay 1
NOTE: Use the “*” key to cancel an entry. The system will generate a dual tone beep for a valid entry code
or three short low tone beeps for an error or invalid entry code.
Standard 4-Digit Code Entry Code (4 digits) Activates the pre-assigned
relay when the code was
created
Special Use 5-Digit Code (Relay 1) Entry Code (4 digits) + 1 Activates relay 1
Special Use 5-Digit Code (Relay 2) Entry Code (4 digits) + 2 Activates relay 2
Loading ...
Loading ...
Loading ...
