Loading ...
Loading ...
Loading ...
4
pH PERMISSIVE CONTROL SYSTEM
OPERATOR’S MANUAL
8.914-301.0-D • PH-3020 Permissive Control System
IMPORTANT
SAFETY INFORMATION
CAUTION: To reduce the risk of
injury, read operating instruc-
tions carefully before using.
ATTENTION: Pour réduire
le risque de blessures, lire at-
tentivement les instructions de
f n c t i o n n e m e n t a v a n t
l'utilisation.
1. Read the owner's manual
thoroughly. Failure to follow instructions could cause a
malfunction of the machine and result in death, seri-
ous bodily injury and/or property damage.
DANGER: Meet the National
Electrical code and local codes
for all wiring.
DANGER: Respecter le Code na-
tional de l'électricité et les codes
locaux pour tous les câblages.
2. The installation of the machine
must comply with local and/or
national codes.
WARNING: All wiring must be
performed by a qualified electri-
cian.
AVERTISSEMENT: Tout le câblage doit être effectué
par un électricien qualifié.
WARNING: Ground system before connecting to the
power supply.
AVERTISSEMENT: Mettre le système à la masse
avant de le raccorder à la source d'alimentation.
3.Do not spray water near electrical components.
4. Never make adjustments on the machine while it is
in operation except those prescribed in this manual.
5. Before servicing the machine, refer to the MSDS on
all of the material identified in the waste stream. You
must comply with all warnings and wear all protective
clothing stated on the MSDS.
6. Be certain coupled hoses have been locked before
operating.
7. Inlet water temperature must not exceed 104°F
(40°C).
8. When making repairs disconnect machine from
electrical source.
9. The best insurance against an accident is precaution
and knowledge of the equipment.
WARNING
CAUTION
READ OPERATOR’S
MANUAL
THOROUGHLY
PRIOR TO USE.
HAZARDOUS
VOLTAGE CAN
SHOCK, BURN
OR CAUSE DEATH.
GROUND SYSTEM
BEFORE CONNECTING
TO POWER SUPPLY
PRIOR TO US
E.
DANGER
10. WATER MAZE is not liable for any modifications
or the use of components not purchased from
WATER MAZE.
11. Components will freeze and must be located in a
heated enclosure in cold climates.
Loading ...
Loading ...
Loading ...