Loading ...
Loading ...
Loading ...
1312
OPERATION
BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the blower
for the rst time, place the battery pack in the battery charger and charge. Make sure to read all
safety precautions, and follow the instructions in the Battery Charger section.
To install (See Figure 5.)
1. Align the tongue (3) of the battery pack with the cavity (4) in the blower housing.
2. Grasp the blower (2) rmly.
3. Push the battery pack into the handle until the latch locks into place.
4. Do not use force when inserting the battery pack. It should slide into position and “click”.
To remove (See Figure 5.)
1. Press the latch button (1) on the battery pack down and hold.
2. Grasp the blower (2) rmly, and pull the battery pack out of the handle.
NOTE:
The battery pack ts into the handle snugly in order to prevent accidental dislodging. It
may require a strong pull to remove it.
WARNING
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or re:
• Replace the battery pack or the charger immediately if the battery case or charger cord is dam-
aged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the section entitled Charging Proce-
dure.
OPERATION
HOLDING THE BLOWER/
MULCHER(See Fig.7)
Before operating the unit, stand in
the operating position. Check for the
following:
• Operator is wearing proper cloth-
ing, such as boots, safety glasses
or goggles, ear/hearing protection,
gloves, long pants and a long sleeve
shirt.
WARNING
To avoid serious personal injury, wear
goggles or safety glasses at all times
when operating this unit. Wear a face
mask or dust mask in dusty locations.
WARNING
To prevent serious personal injury or
damage to the unit, make sure the
blower tube or the mulcher tubes and
the bag are in place before operating
the unit.
2
Fig. 5
Fig. 6
Fig. 7
STARTING/STOPPING THE
BLOWER/MULCHER (See Fig.6)
1. Press the On/Off ( ) Switch and
you will hear beeping sounds, and the
blower will turn on in low speed.
2. Roll the variable speed dial forward
to increase speed from 70MPH to
130MPH
3. Press the low/high switch( )
to increase the speed options from
75MPH to 185MPH.
4. To Turn off, press the on/off switch
( )
IMPORTANT: TURBO-MULCH by
pressing the “LOW/HIGH button, with
the variable speed dial set to high
speed (5).
ON/OFF
SWITCH
LOW/HIGH
SWITCH
VARIABLE
SWITCH
4
3
1
Loading ...
Loading ...
Loading ...